欢迎进入「长春道闸」升降柱-自动路桩-液压路障机-长春宏创科技有限公司网站
全国服务热线
13940183063
公司新闻
「长春道闸」小区挡车器能抬杆不能落杆的原因
时间: 2019-07-30 09:52 浏览次数:
道闸不能落杆的原因,四平道闸怎么换弹簧,白城栅栏道闸批发,吉林车牌识别收费道闸「长春道闸」小区挡车器能抬杆不能落杆的原因

「长春道闸」小区挡车器能抬杆不能落杆的原因


Reasons why the block of Changchun Road Gate can lift the rod and can not drop the rod




如今,住宅小区的安全管理问题被越来越重视,自动道闸成为不不可少的公用防护设施。


Nowadays, more and more attention has been paid to the safety management of residential quarters, and automatic sluice has become an indispensable public protection facility.


可配合蓝牙,车牌识别,门禁等设备使用,禁止外来车辆随意进入小区,有效改善停车环境,增加业主安全。


It can cooperate with Bluetooth, license plate recognition, access control and other equipment, prohibit foreign vehicles from entering the community at will, effectively improve the parking environment, and increase owner safety.


在您使用和安装小区道闸的过程中,是否有遇得到过道闸能够抬杆,但是不能落杆的情况呢 。


In the process of using and installing the small lane gate, are there any cases where the lane gate can lift the pole, but can't drop the pole?


这种故障,通常有两个原因,一是下限位没有调试好,另一个可能性就是配重原因。


There are usually two reasons for this failure. One is that the lower limit is not well debugged. The other possibility is that the counterweight is the cause.



长春栅栏道闸批发
 


「长春道闸」小区挡车器能抬杆不能落杆的原因


easons why the block of Changchun Road Gate can lift the rod and can not drop the rod


以下是宏创科技为您整理的一些关于小区道闸的常见故障,希望对您有所帮助。

Following are some common failures of the sluices in the residential districts that Hongchuang Technology has sorted out for you. I hope it will be helpful to you.


一、道闸落杆状态栏杆低于水平位置的可能原因


1. Possible Reasons for Rail Bar Lower than Horizontal Position


1、控制落杆的下限位开关螺丝松动.


1. Lower limit switch screw of control drop rod is loosened.


2、栏杆过重.


2. Overweight railings.


3、电机的蜗轮磨损,致电机的自锁性变差,机器出现冲限位.


3. Worm wheel wear of motor results in poor self-locking of motor and impulse limit of machine.


4、控制器动作速度慢,致机器出现冲限位


4. The slow motion of the controller causes the machine to have impulse limit.


5、与连杆连接的臂与轴三发生相对转动


5. Relative rotation of arm and axle three connected with connecting rod


二、「长春道闸」落杆状态栏杆低于水平位置对应的解决方法


2. Solutions to the lower horizontal position of the balustrade in the falling state of Changchun Road Gate


1、重新调试下限位后,再拧紧下限位螺丝.


1. After debugging the lower limit, tighten the lower limit screw.


2、增加接簧


2. Increase the springs


3、更换电机.


3. Replace the motor.


4、更换控制器


4. Replacement of Controller


5、重新调试机器并拧紧臂上的螺丝


5. Re-adjust the machine and tighten the screw on the arm


三、落杆状态栏杆高于水平位置的可能原因


3. Possible Reasons for Railing Over Horizontal Position


1、控制落杆的下限位开关螺丝松动.


1. Lower limit switch screw of control drop rod is loosened.


2、栏杆缩短.


2. Shortening of railings.


3、与连杆连接的臂与轴三发生相对转动


3. Relative rotation of arm and axle connected with connecting rod


四、落杆状态栏杆高于水平位置对应的解决方法


4. Solutions to the above-horizontal position of the falling railings


1、重新调试下限位后,再拧紧下限位螺丝.


1. After debugging the lower limit, tighten the lower limit screw.


2、减少拉簧,同时微调调节螺套


2. Reduce the tension spring and fine-tune the adjusting screw sleeve at the same time


3、重新调试机器并拧紧臂上的螺丝


3. Re-adjust the machine and tighten the screw on the arm


「长春道闸」厂家电话:13940183063,如您再道闸使用过程中需要问题咨询,欢迎来电。


Changchun Road Gate Manufacturer Telephone: 13940183063. If you need to consult during the use of the re-gate, please call us.

Copyright © 「长春道闸」升降柱-自动路桩-液压路障机-长春宏创科技有限公司 版权所有 辽ICP备:备案中···
全国服务电话:13940183063   售后服务:4006-080-090
公司地址:吉林省长春市朝阳区硅谷大街58号

百度地图 - 网站地图